| Quantity: | |
|---|---|
Pneumatic Wick Cutting Machine with PLC Touch Screen and Adjustable Cutting Length for Prewaxed Cotton Candle Wick Preparation
The YD-09 Pneumatic Wick Cutting Machine is designed for cutting prewaxed cotton wicks during candle wick preparation. Cutting length, speed and operating parameters can be adjusted through the PLC touch screen, allowing the setup to be matched to the intended wick-processing job.
The machine uses pneumatic and electric operation and accommodates different wick-holder sizes. It provides a dedicated cutting stage for candle makers preparing wicks to specified lengths, with the wick, holder and cutting setup checked together before production.
PLC Touch-Screen Adjustment: Cutting length, speed and operating parameters are adjusted from the PLC touch screen, bringing the main cutting settings together at the operator interface.
Prewaxed Cotton Wick Processing: The machine is intended for prewaxed cotton wicks, providing a dedicated cutting operation within the candle wick preparation workflow.
Adjustable Cut Length: The listed wick-length range is 20-1000mm. Select the required length for the production job and confirm the cutting result using the intended wick material.
Different Wick-Holder Sizes: The machine accommodates various wick-holder sizes rather than being described as a single-size unit. Match the holder and wick specifications before production.
Pneumatic and Electric Operation: The equipment combines pneumatic and electric operation. Its listed electrical supply is 220V, 50Hz, single phase; compressed-air requirements should be confirmed separately.
Cutting prewaxed cotton candle wicks to the required length.
Preparing wicks for subsequent candle assembly operations.
Adjusting cutting settings between different wick-processing jobs.
Candle workshops using more than one wick-holder specification.
Confirm the incoming wick specification and selected holder size, then establish the required cut length and speed through the PLC interface. Check sample cuts before a production run. The final setup and safe operating procedure should follow the equipment manual.
Item | Specification |
|---|---|
Product Name | Pneumatic Wick Cutting Machine |
Model | YD-09 |
Power Supply | 220V, 50Hz, Single Phase |
Power | 600W |
Drive Type | Pneumatic and Electric |
Wick Size | 0.86-3mm |
Wick Tab Sizes | 12.5 x 2.5mm; 14 x 3mm; 16 x 3mm; 20 x 5mm |
Wick Length | 20-1000mm |
Speed | Product sheet states 12000 m/hour; confirm the unit and test conditions |
Machine Size | 50 x 50 x 170cm |
Weight | 150kg |
Control | PLC Touch Screen |
Adjustable Settings | Cutting Length, Speed and Operating Parameters |
Intended Material | Prewaxed Cotton Wick |
Parameter Notes: The dimensions under wick tab sizes are reproduced as paired values from the product sheet; the meaning of each dimension should be checked against the actual tab drawing. The speed is not converted into pieces per hour. No cutting-accuracy tolerance is specified in the supplied material.
Please provide wick samples, wick diameter, target cutting lengths and the intended wick-tab drawing or samples. Confirm the supplied holder/tooling set, any changeover requirements, required output and acceptable cutting tolerance. Also confirm compressed-air pressure and consumption, which are not listed in the product sheet.
